Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car



Mercedes W202
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
- 13. Body
   13.2. Forward door
   13.3. Back door
   13.4. Handle of a forward door
   13.5. Handle of a back door
   13.6. Door lock
   13.7. Internal covering of doors
   13.8. Forward window regulator
   13.9. Glass of a forward window
   13:10. Back window regulator
   13:11. Glass of a forward door
   13:12. Window regulator engine
   13:13. Glove boxing
   13:14. Gear shifting handle sheeting
   13:15. Forward ashtray
   13:16. Average console
   13:17. Heating service panel
   13:18. Internal covering of the A-rack
   13:19. Internal covering of the S-rack
   13:20. Front seat
   13:21. Back seat
   + 13:22. Central lock
   13:23. External mirror / glass of a mirror
   13:24. A covering under the dashboard
   13:25. Front bumper
   13:26. Rear bumper
   13:27. Internal wing of the car
   13:28. Car wing
   13:29. Lattice Mercedes radiator / emblem
   13:30. Draft of a cowl of the engine
   13:31. A covering under a windshield
   13:32. The air supply device for heating of salon
   13:33. Catchment basin
   13:34. Paint and varnish covering
   13:35. Metal corrosion
   13:36. Automake-up
   13:37. What creaks?
   13:38. Hatch
+ 14. Electric equipment
+ 14.2. Electrical circuitries




13:33. Catchment basin

GENERAL INFORMATION

4. Catchment basin
5. Rubber support of screen wipers
6. Fastening bolt on the right
8. A hose for water discharge
10. The channel for pipelines

4. Catchment basin
7. Air access device clips
9. Spillway
11. Middle part of a partition
12. Collar
13. Bolt
14. Spring clip
15. A support of the operating device
16. Six-sided nut

Removal

PERFORMANCE ORDER
1. Remove a covering under a windshield.
2. Remove the device of screen wipers.
3. Unscrew two rubber support (5).
4. Disconnect 4 clips (7), unscrew one bolt (6).
5. Disconnect the channel of wires (10).
6. Disconnect a collar (12) fuel-supply lines.
7. Unscrew 4 screws (13), wring out 2 spring clips and remove a middle part of a partition (11).
Prevention

At installation of a middle part of a partition to pay attention to a rubber tip for bringing heating hose to the former place.


8. Remove a support of the monitor (15) for what unscrew three nuts (16).
9. Take a catchment basin.
Prevention

When replacing a catchment basin to monitor the correct provision of a spillway and drain hose.


Installation

Installation is made in the sequence, the return to removal.