Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car

Mercedes W202
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
- 13. Body
   13.2. Forward door
   13.3. Back door
   13.4. Handle of a forward door
   13.5. Handle of a back door
   13.6. Door lock
   13.7. Internal covering of doors
   13.8. Forward window regulator
   13.9. Glass of a forward window
   13:10. Back window regulator
   13:11. Glass of a forward door
   13:12. Window regulator engine
   13:13. Glove boxing
   13:14. Gear shifting handle sheeting
   13:15. Forward ashtray
   13:16. Average console
   13:17. Heating service panel
   13:18. Internal covering of the A-rack
   13:19. Internal covering of the S-rack
   13:20. Front seat
   13:21. Back seat
   + 13:22. Central lock
   13:23. External mirror / glass of a mirror
   13:24. A covering under the dashboard
   13:25. Front bumper
   13:26. Rear bumper
   13:27. Internal wing of the car
   13:28. Car wing
   13:29. Lattice Mercedes radiator / emblem
   13:30. Draft of a cowl of the engine
   13:31. A covering under a windshield
   13:32. The air supply device for heating of salon
   13:33. Catchment basin
   13:34. Paint and varnish covering
   13:35. Metal corrosion
   13:36. Automake-up
   13:37. What creaks?
   13:38. Hatch
+ 14. Electric equipment
+ 14.2. Electrical circuitries

13:28. Car wing

Removal

PERFORMANCE ORDER

1. Remove a front bumper.
2. Remove lamps of indexes of turn.
3. Remove an internal wing.
	4. Remove decorative levels (moldings) hands or wring out the wide plastic pallet.
	5. Open a door and unscrew back bolts of a wing of the car.
Prevention At the same time paste over with the gluing tape a door in working area not to damage a varnish covering.
6. Unscrew a wing from below.
	7. Unscrew a wing from above (five bolts) and from below in the field of a bumper.
8. Unscrew two bolts in a cut for indexes of turn.
	9. Unscrew bolts on a blenda below a headlight and remove a blenda.
10. Extend a wing forward and remove it.

Installation

PERFORMANCE ORDER

1. Cover a car wing with enough protective lubricant for the bottom from within.

2. Establish and level a wing. The wing has to be flush with the closed forward door or to be at most 1 cm higher. The gap between a wing and the closed engine cowl, and also a forward door should be checked.

3. Screw all bolts of fastening and smoothly tighten.

4. Double-check position of a wing of the car.

5. Preserve a cavity over an internal wing wax through a cut of indexes of turn.

Prevention

From above in a wing before putting wax to paste over an opening with an adhesive tape. After putting wax to shoot the film.

6. Establish a bumper.

7. Establish an internal wing.

8. Mount the blinking index of turn.

9. Fix decorative levels.