Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car

Mercedes W202
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
- 8. Fuel system
   - 8.1.1. Introduction
      8.1.2. Fuel tank
      8.1.3. Fuel level sensor
      8.1.4. Fuel pump
      8.1.5. Fuel filter
      8.1.6. Air filter
      8.1.7. Cross pipe of the air filter
      8.1.8. Inlet gas pipeline
      8.1.9. Cable gas / lever of a butterfly valve (DB)
      8.1.10. Cable of management of gas (DB)
      8.1.11. Contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. Fuel thermostat
      8.1.14. Hydrovalve case
      8.1.15. Cable gas / lever of a butterfly valve (DD)
      8.1.16. Cable of management of gas (DD)
   + 8.2. System of injection of petrol engines
   + 8.3. System of injection and power supply of diesel engines
   + 8.4. System of production of exhaust gases
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electrical circuitries

8.1.16. Cable of management of gas (DD)

GENERAL INFORMATION

DIESEL ENGINE

Prevention

The cable is very sensitive to bends and therefore at installation demands the accurate address. The only easy bend can lead to its later breakage at operation of the car. Therefore cables which were earlier bent it is not necessary to establish.

Removal

PERFORMANCE ORDER

1. 2,0 l engine: unhook a cable of management of gas (230) on the adjusting lever (208). For this purpose squeeze out the directing detail (240).

2. 2,2 / 2,5 l engines: unhook a cable of management of gas on a spherical head of the directing lever.

3. Squeeze a plastic spring clip (228) and pull out the hummock drive from a support (225).

4. Dismantle a casing under the dashboard.

5. Unhook fastening of the hummock drive (shooter) on the lever of a pedal of an accelerator (223). For this purpose unhook a returnable spring (235) and extend the holder (233/2) together with an expansion bolt.

6. Press from internal space of the car outside a cable of management of gas. At the same time do not squeeze out the rubber plug.

7. Remove a cable of management of gas in a set.

Installation

PERFORMANCE ORDER

1. Grease a cable of management of gas between the directing element and a tip anticorrosive plastic lubricant like Mercedes-000 989 5110.

2. Instruction: at vehicles with the automatic transmission the cable of management of gas is established in its fastening together with a spring (shooter). Thanks to it the way of the lever of a pedal increases and the opportunity of switching off of the switch of a pedal of an accelerator is given.

3. Check the rubber plug (231) for damage or porosity, if necessary replace.

4. Stretch a cable of management of gas in internal space of the car and suspend on the accelerator lever. Pick up a returnable spring.

5. Mount a casing under the dashboard.

6. Enter a cable of management of gas through an opening in a support, press on a support and record.

7. 2,0 l engine: hang a cable of management of gas on the adjusting lever and record it by means of the directing detail (240).

8. 2,2 / 2,5 l engine: press a cable of management of gas on a spherical head of the directing lever.

9. Adjust a cable of management of gas.