|
Mercedes of the S-class W2021993-2000 of releaseRepair and operation of the car |
|
Mercedes W202 - 1.2. General information 1.3. Maintenance 1.4. Keys 1.5. Doors 1.6. Seats + 1.7. Security systems + 1.8. Equipment of salon + 1.9. Driving 1.10. Engine cowl 1.11. Ventilation block, conditioner 1.12. Several councils upon purchase of the car 1.13. The changed numbers 1.14. Purchase of the old car 1.15. Durability of the car 1.16. About parallelism of bridges of the car and trailer + 1.17. Preparation of the car for winter + 2. Maintenance + 3. Engines + 4. Lubrication system + 5. Cooling system + 6. Heating, ventilation + 7. System of ignition + 8. Fuel system + 9. Transmission + 10. Running gear + 11. Steering + 12. Brake system + 13. Body + 14. Electric equipment + 14.2. Electrical circuitries |
1.6. Seats
Change of provision of a front seat On length: To lift the handle (1) up, to move a seat forward or back, to fix the handle (1). Pillow inclination for sitting: To rotate a wheel (2) forward or back. Seat height: to lift the regulator (3). To move sitting = forward to establish above. To move a seat = back to establish below. To fix the regulator. Back inclination: Forward or to rotate a wheel (4) to the necessary situation back. Seat head restraint: for installation on height slightly to press them forward. To establish a head restraint so that the nape was propped up approximately at the level of ears. At the same time it is impossible to pull out a head restraint further of the provision of an emphasis. Switches are in forward doors. Key in the steering lock in situation 1 or 2 (at an open forward door, and also at the taken-out key or the provision of a key "0"). Installation of a seat and head restraint: A. Change of provision of a pillow of a seat. B. Change of provision of a seatback. C. Change of provision of a head restraint. Establish a head restraint so that the nape was propped up approximately at the level of ears. The head restraint can also be regulated manually forward. Prevention Input and storing of provision of a seat and head restraint: D. Button of input and storing. E. 1 and 2 positions buttons. 2 provisions can be entered, after installation of a seat and a head restraint to press the button of input and storing of D, to release it and within 3 seconds to press the position button 1. By means of the position button 2 one more installation of provisions of a seat and a head restraint can be entered and kept. Call of the provisions of a seat and head restraint which are stored in memory: At emergence of need for installation of desirable provisions of a seat and a head restraint, press the corresponding position button until there is a desirable installation. If to release the position button, then for safety reasons installation process will be interrupted at once. Orthopedic seatback For providing the correct position of a backbone in a seatback there are airbags. Situation and pressure force of a back of sitting are put at situation 2 locks of steering. Regulate the step switch (1) pressure in airbags (from "0" = without pressure to 4 – the maximum pressure). Provisions of a seatback are established by the switch (2) from situation "A" – the lowest to "Е" – the highest. After the termination of a trip the last chosen situation is established automatically anew. Heating of a seat Key in the steering lock in situation 2. To include: To press 1 = the normal mode of heating. In the switch the control bulb burns To press 2 = bystry heating. In the switch both control bulbs burn. After about 5 minutes heating of a seat will switch automatically to a normal operating mode and in the switch only one control bulb will burn. To include: If in the switch one control bulb burns, to press 1. If in the switch 2 control bulbs burn to press 2. Automatic shutdown of heating of a seat will happen approximately in 30 minutes. Prevention If many consumers of energy are included or the accumulator is insufficiently charged, heating of a seat can automatically be turned off. In this case the control bulb blinks (at bystry heating both bulbs blink). As soon as the required tension appears again, heating of a seat joins automatically. If blinking of control bulbs disturbs, you can switch off heating of a seat the switch. Armrest of a front seat Situation 1 – the armrest is lifted. Situation 2 – at the normal provision of a seatback. Situation 3 – at strongly inclined provision of a seatback. For lowering of an armrest press the button (4). Prevention Armrest of a back seat To pull out armrests for a loop. Head restraints of a back seat To establish head restraints of a back seat so that the nape was propped up approximately on the line of ears. |
По материалам сайта http://saudar.net
|