|
REASON
|
WAY OF ELIMINATION
|
|
Too big single way of a brake pedal
|
Frictional slips are in whole or in part worn-out
| Replace brake frictional slips. |
| Failure of one of contours of braking | Check braking contours for leak of brake fluid. |
|
The brake pedal far leaves when pressing and springs
|
| Air in the brake system | Remove air from brakes. |
| Too little brake fluid in a leveling tank | Add new brake fluid. |
| Frictional brake slips are behind strongly worn-out, the payment of the basis of a slip adjoins to a spring | Replace frictional slips. Use company frictional slips. |
| Production of steam. Happens at strong loading, for example, when driving on the pass | Replace brake fluid. Remove air from brakes. |
|
Slayuy action of brakes, brake pedal should be pressed to the full
|
| Leakage of the pipeline | Tighten elements of connection of the pipeline or replace it. |
| Damage of a cuff to the main thing or wheel brake cylinder | Replace a cuff. At damage of a cuff to the main cylinder replace internal details or the cylinder. |
| Damage of stationary rubber laying | Repair a support. |
|
Bad brake effect, despite strong pressing a brake pedal
|
| Frictional slips are oiled | Replace frictional slips. |
| The unsuitable or hardened frictional slip | Replace frictional slips. Use only company frictional slips. |
| The amplifier of braking is faulty | Check usiliteltormozheniye. |
| Jamming of the piston | Provide a free wheeling of a support. |
| Pollution of hydraulic system | Clear, replace brake fluid. |
| Frictional slips are worn-out | Replace frictional slips. |
|
Brakes creak
|
| Frictional slips are worn-out | Replace frictional slips. |
| A consequence of atmospheric influences (humidity of air) is frequent | No actions are required if the scratch is observed after the long parking of the car at high humidity and after the first braking does not repeat. |
| Unsuitable frictional slip | Replace frictional slips. Use company frictional slips. Cover the slip basis with paste an anti-scratch. |
| The brake disk rotates is nonparallel to a support | Check a support prileganiye surface. |
| The polluted wells in a support | Clean support wells. |
| Wrong installation of pistons in supports of back wheels | Check 20-degree installation of pistons. |
|
Brakes are blocked at easy braking
|
| Frictional slips are not oiled | Replace frictional slips. |
|
The brake drags on spontaneously
|
| The compensation opening in the main brake cylinder is littered | Clean the main brake cylinder and replace internal details. |
| Too small gap between the operating bar and the piston of the main brake cylinder | Check a gap (work in repair shop). |
|
Frictional slips do not separate from a brake disk, wheels hard turn a hand
|
| Corrosion in cylinders of supports | Repair a support, in case of need – replace. |
|
Uneven wear of slips
|
| Unsuitable frictional slip | Replace brake slips. Use company frictional slips. |
| The support is polluted | Clean support wells. |
| Hard piston stroke | Check installation of the piston. |
| Leakage of the brake system | Check tightness of the brake system. |
|
Pulsation of a brake pedal
|
| Too big admission on thickness or a side beating of a brake disk | Check a beating and the admission. Finish a brake disk or replace. |
| The brake disk rotates not parallel to a support | Check a support prileganiye surface. |
| Functioning of the anti-blocking ABS system | Does not demand any actions, the normal phenomenon |
|
Vibration of brakes
|
| Unsuitable frictional slip | Replace frictional slips. Use only company frictional slips. |
| Partial corrosion of a brake disk | Carefully smooth out a disk a grinding block. |
| Side beating of a brake disk | Finish or replace a brake disk. |
|
The brake pedal slowly falls by easy pressing
|
| Malfunction of the main brake cylinder | Replace the main brake cylinder. |
|
Unilateral action of brakes
|
| Air pressure in tires does not correspond to ordered | Check air pressure in tires and correct. |
| Unevenness of wear of tires | Replace worn-out tires. |
| Frictional slips are oiled | Replace frictional slips. |
| Malfunction of a suspension bracket of a wheel or steering | Check |
| Razliny types of slips on one axis | Replace frictional slips. Use company slips. |
| Bad contact of frictional slips | Replace frictional slips. |
| The pipeline is littered | Check the brake pressure of all four brakes. |
| The polluted support wells | Clean the surface of landing and guides of a surface of frictional slips in a support. |
| Corrosion in support cylinders | Replace a support. |
| Uneven wear of frictional slips | Replace frictional slips (both wheels). |
|
Brakes heat up in the course of the movement
|
| The compensation opening in the main brake cylinder is littered | Clean the main brake cylinder and replace internal details. |
| Unsatisfactory idling of a pusher of the main brake cylinder | Check existence of a sufficient gap between a pedal and a pusher and, in case of need, adjust. |
| Jamming of the brake piston or its rigidity | Restore passability. |
| The brake pipeline is littered | Clean truboporovoda, replace brake fluid. |
| Wrong adjustment of the parking brake | Correctly adjust. |